Nabis B08911 Instructions & Warranty page 3

Mono kitchen mixer

Installation Requirements

Flexible Pipes Connection

Please ensure flexible pipes are connected to the household pipework with extra care to avoid the flexi pipes are not kinked, twist

or bent sharply.

Below are recommended ways to fit the flexible pipes during tap installation. Failure to follow the below recommended

guidelines may damage the flexible pipes or poor taps performance.

min.

80mm

min.

15mm

Mono kitchen mixer

Tap Body

Flange (if supplied)

Anti-rotational washer

Fixing rod

C shaped rubber washer

C shaped metal washer

Fixing nut

Flexible tails

1. Identify all components and check for completeness, particularly before commencing installation.

2. Screw fixing rod to tap body and tighten it.

3. Fit flange to tap body, ensuring that the anti-rotational washer is fitted between the flange and the sink. if the flange is not

supplied, fit anti-rotational washer directly to the tap body.

4. Screw 2x flexible tails into tap body, do not over tighten.

5. Locate the tap assembly down through the tap hole in sink.

6. Slide the C shaped rubber washer and the C shaped metal washer onto the fixing rod up to the underside of the sink. To secure

the mixer in place tighten the fixing nut onto the fixing rods until they fully tightened against the C shaped metal washer.

A suitable spanner may be required to fully tighten the fixing nuts.

7. Connect the flexible tails to the hot and cold water supplies.

8. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.

9. Check all joints and connections for any leaks.

max.

3Nm