Table of Contents
Advertisement
Pour the detergent and laundry care product into the
appropriate chambers:
Detergent
for liquid detergent
dispenser A
Dispenser I
Detergent for pre-wash
Fabric softener, starch
Dispenser
i
Do not exceed max
Tips
Do not pour fabric softener directly into
the wash load.
Fabric softener is automatically dis-
pensed during the last rinse cycle.
Dilute concentrated or thick fabric soft-
ener or fabric conditioner with water (2/
3's water) before pouring it into the dis-
penser (prevents blockage of overflow).
Dispenser II
Detergent for main wash, water softener,
spot remover,
NOTICE: Do not use bleach and liquid
chlorine bleach or color safe bleach.
Open the detergent dispenser drawer.
1.
Add detergent or additive.
2.
Avoid overfilling the compartment to prevent early
3.
dispensing.
Close the detergent dispenser drawer completely
4.
before starting the wash cycle.
Tip: DO NOT operate the washer without the detergent
compartment in place and fully closed.
Liquid detergent dispenser
To measure liquid detergent:
Pull out the detergent drawer. Press down on the insert
1.
and remove the drawer completely.
Push the liquid detergent dispenser forward.
2.
Insert the drawer again.
3.
NOTICE: Do not use the liquid detergent dispenser with
gel-type detergents and powdered detergents or for
cycles with pre-wash and selected Delay Start.
Starting the cycle
Press the Start/Pause button Indicator lamp lights up
and the cycle starts.
NOTICE: If you want to protect the cycle against
inadvertent adjustment, select the child lock.
~ Child lock; Page 25
During the cycle, the display field indicates the "Finish at"
time and, after starting the washing cycle, the cycle
duration and the symbols for the cycle progress.
~ Display field; Page 17
Child lock
You can secure the washer against inadvertent changing
of the set functions. To do this, activate the child lock
after cycle start.
To Activate/Deactivate, press Start/Pause for approx. 5
seconds. In the display field, you will see the
lit steady: The child lock is active.
D
▯
D
blinking: The child lock is active and the cycle
▯
selector has been adjusted. To prevent a cycle
interruption, set the cycle selector back to the initial
cycle. The symbol lights up again.
NOTICE: The child lock can remain activated until the
next cycle start even after switching the machine off.
Then you must deactivate the child lock before cycle
start and if necessary activate it again after cycle start.
Selecting a different cycle
If you have inadvertently started the wrong cycle, you can
change this as follows:
Press Start/Pause.
1.
Select another cycle.
2.
Press Start/Pause. The new cycle starts from the
3.
beginning.
Pausing/Continuing the cycle
e.g. for soaking ~ Soaking; Page 21
Press Start/Pause. -
- appears on the display panel;
¿
washing machine door cannot be opened. To continue
the cycle, press Start/Pause.
Cancel cycle
For cycles with a high temperature:
Press Start/Pause.
1.
Cool the laundry off: Select Rinse.
2.
Press Start/Pause.
3.
For cycles with a low temperature:
Press Start/Pause.
1.
Select Spin/Drain.
2.
Press Start/Pause.
3.
symbol.
D
25
Advertisement
Table of Contents
Troubleshooting
