Installing The Doorphone - Panasonic VL-MW274 Installation Manual

Installing the doorphone

Important:
R On the bottom surface of the doorphone and the
mounting base, there are holes to allow water to
drain. Do not cover them up when installing.
R When existing wiring (such as chime wires) is
used:
– It may contain AC voltage that may cause
electric shock and/or damage the product.
– Never use the following types of wiring.
Consult a qualified technician/dealer.
R See "Wire type and length" for information about
wiring materials.
1
Remove the mounting base.
A Open the screw cover (A).
A
B
B Screwdriver
B Loosen the mounting screw (C).
C
D
D Water drain holes
E Mounting base
E
2
Attach the mounting base (A) to the wall
securely using the wood screws (B)
(accessory).
R Install the mounting base on a vertical flat
wall.
R Before drilling, refer to "Precautions for
installation" for installation location.
B
A
C Wire (locally procured)
D 83.5 mm
*1 To prevent dew condensation, fill a hole for
wiring as much as possible.
3
Adjust the camera angle using the camera
angle control lever.
Rear view
A Camera angle control lever
B Left (maximum 15°)
C Right (maximum 15°)
D Upwards (maximum 15°)
*1
C
B C
D
D
A
9