Safety Information - Coleman CMBG750 User Manual

Reference
Troubleshooting Guide
Your Battery Generator features several built-in protection features to ensure safe and efficient operation. Below is a guide which shows the typical faults that occur during normal operation and how to correct them and resume use.
If a fault occurs, the following warning(s) will appear on the intelligent LCD screen. Please refer to the table below to safely correct any problems and allow your Battery Generator to reset and resume operation. If you have additional
questions, please contact Customer Service at 888-617-5884.
Fault Type
HI TEMP / LO TEMP
Your Battery Generator is too hot or too cold (operating temperature range is -10° to 45° C / 14° to 113° F)
OUTPUT OVERLOAD
Excessive power draw
LOW BATTERY
Low battery voltage (<9V)
Flashing icon Solar Input range exceeded (See Product Specifications)
Shuts down after 5 hours Shuts down to save battery charge when it detects low power need
Unit is not charging
The Input Overload Switch may have tripped due to a fault in the AC input source

Safety Information

This section contains important safety information. Before using the product, READ ALL instructions and cautionary markings on or provided with the product, and all appropriate sections of this guide. The product contains no
user-serviceable parts. SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
WARNING – When using this product, basic precautions should always be followed,
including the following:
a) Read all the instructions before using the product.
b) To reduce the risk of injury, close supervision is necessary when the product is used near children.
c) Do not put fingers or hands into the product.
d) Do not expose Battery Generator to rain or snow.
e) Use of an attachment not recommended or sold by Battery Generator manufacturer may result in a risk
of fire, electric shock, or injury to persons.
f) To reduce risk of damage to the electric plug and cord, pull the plug rather than the cord when
disconnecting the Battery Generator.
g) Do not use the Battery Generator or appliance that is damaged or modified. A damaged or modified
Battery Generator may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
h) Do not operate the Battery Generator with a damaged cord or plug, or a damaged output cable.
i) Do not disassemble the Battery Generator, take it to a qualified service person when service or repair is
required. Incorrect reassembly may result in a risk of fire or electric shock.
j) To reduce the risk of electric shock, unplug the Battery Generator from the outlet before attempting any
instructed servicing.
PERSONAL PRECAUTIONS
a) When charging the internal battery, work in a well ventilated area and do not restrict ventilation
in any way.
b) Do not expose a Battery Generator to fire or excessive temperature. Exposure to fire or temperature
above 130°C / 266°F may cause explosion.
FCC / ISED Information
This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
CAN ICES-003 (B) / NMB-003 (B)
(cont'd)
What it means
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
What to do
Move the Battery Generator to a cooler or warmer location as needed
Remove some of the connected items to lower the total draw on the Battery Generator, then turn it on again.
Charge the Battery Generator
Check solar panel configuration
Press and hold power button to go into Power Safe Off mode, LED flashes in this mode.
NOTE: Turning port off cancels the Power Save Off mode.
Check AC input source to make sure there are no short circuits, then push in the red input overload
switch to reset it, and turn it back on.
WARNING: NO USER SERVICEABLE PARTS
• There are no user serviceable parts in this unit, DO NOT attempt to open the Battery Generator; this is
dangerous and will void the warranty.
WARNING: HEAT GENERATION DURING CHARGING AND USE
• Charging and discharging generates heat and requires proper air flow. Use in a ventilated area and
ensure adequate clearance for the ventilation grills. Blocking the grills may cause overheating and
damage to the unit.
WARNING: RISK OF ELECTRIC SHOCK INJURY
• Do not operate or store in moist conditions to avoid electric shock.
• If the unit gets wet wait for it to dry completely before using it.
• Do not insert foreign objects into any of the ports or openings.
WARNING: RISK OF ELECTRIC SHOCK OR FIRE HAZARD
• Review the specifications of the Battery Generator ports and all connected devices you intend to use.
• The output ports can generate dangerous voltages.
• Do not use the Battery Generator if it is damaged or any of the input or output cords are damaged.