Troubleshooting - FreshWater Salt System Owner's Manual

Status Message on Screen
Okay
Inactive-System Off
System Testing
24-Hour Boost Cycle On
1. Dip Test Strip
2. Balance Water
3. Soften Water
4. Adjust Level & Confirm
Inactive-Summer Timer On
Inactive-High Status
1. Dip Salt Strip
2. Check/Replace Cartridge
Inactive-Low Status
1. Dip Salt Strip/Clean Filter
2. Check/Replace Cartridge
Cartridge Reached 4 Months
Replace Cartridge?
Remove Cartridge Now
Insert New Cartridge
Press System Restart
Salt System Restarting...
Service Required Contact
Dealer Error #

Troubleshooting

Treating for Metals
High metal content can cause staining and discolored water. It is important that
metals are removed before starting up the Salt System.
1. Fill the spa with the FreshWater Clean Screen pre-filter per instructions.
2. Ensure that there is no ozone unit installed and that the Salt System is turned to
zero.
3. Add Stain and Scale metal control according to the instructions on the bottle.
4. Use a new FreshWater Vanishing Act Calcium Remover
(following the instructions).
5. DO NOT add chlorine for at least 24 hours.
Page 6
Meaning or Action Required
Operating normally
System Off
Output level is set to 0
System test initiated/in progress
Increasing chlorine level
Output level is set to 10 for 24 hours
FreshWater 5-Way Test Strip
10-day verification
Test water, adjust output level, confirm
using a FreshWater Salt Test strip
System is disabled for eight hours when
Summer Timer is active
Non-operational high salt level detected -
correct salt level; check/replace cartridge
Test water with FreshWater Salt Test strips
and add salt if needed. Check/clean filter.
Replace cartridge.
Replace cartridge now or postpone 7 days
Step 1 of cartridge change process
Step 2 of cartridge change process
Step 3 of cartridge change process
Step 4 of cartridge change process
Contact dealer for service
FreshWater Salt System