Advertisement
Installation
Attach the module to a DSP/OMNI-LIA101 adapter cable as
follows (refer to Figure 1):
1.
Ground yourself by touching a grounded, conductive
surface.
2.
Remove the link interface adapter from the test tool.
3.
Use your fingers to unscrew the screw on the personality
module. If necessary, you can use a flat-blade screwdriver to
loosen the screw.
4.
Remove the module; then store it in its original, static
protection bag.
5.
Put the new module in place and tighten the screw with
your fingers.
Tighten the screw with your fingers only. Do not
overtighten. Doing so can damage the module or the
end of the cable.
Caution
Advertisement
