Saving Energy; Starting A Wash Cycle; Changing The Program Mid-Cycle - Pelgrim GVW350XL Instructions For Use Manual

PROGRAMMING THE DISHWASHER

Saving energy

• Pre-rinsing of tableware items leads to increased water and energy consumption and is not
recommended.
• Washing tableware in a household dishwasher usually consumes less energy and water in
the use phase than hand dishwashing when the household dishwasher is used according
to the instructions.

Starting a wash cycle

1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply can be found on the "rating plate"
which is located on the side of the inner dishwasher door, where also the serial number is
mentioned. Make sure that the water supply is turned on to full pressure.
4. Open the door and press the on/off button to switch on the appliance.
5. Choose a program (and possibly a function) and press the start button.
6. Then close the door, the dishwasher will start its cycle.

Changing the program mid-cycle

A wash cycle can only be changed if it has been running for a short time. Otherwise the
detergent may have already been released and the dishwasher may have already drained the
wash water. If this is the case, the dishwasher needs to be reset and the detergent dispenser
must be refilled. To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher. When the spray arm stops working, you can
open the door completely.
2. Press and hold the Start button for more than three seconds to set the appliance into
program selection mode.
3. You can change the program to the desired cycle setting.
4. Press the Start button and close the door; the dishwasher will start its cycle.
3 sec
72
EN 19