Advertisement
•
Activate the adjustment mode display (SBL item). Ajust SBL from 0 to 1. Blanking the bottom of
the screen.
•
Adjust VSH until the bottom of the pattern be aligned with the reference marks of the mechanical
center on picture tube (the central vertical line in the center of the tube).
•
Adjust VS until the central line be aligned with the half bottom of the screen (the central line of the
circle pattern in the half cut of the screen)
•
Return SBL from 1 to 0 value . The image could be compressed or expanded.
•
Select VA item and set its value to adjust the size of the picture (proportional height and width
picture).
•
If necessary readjust SC item and set its value to adjust the Linearity (acts in the top of the image)
and VA.
NOTE: The SC and VA adjustments are interdependent (they should be used together).
When the image to be decentralized in the vertical, to retouch VSH and/or VS
3.7 Horizontal Adjustment
•
Apply a Circle Pattern Philips (RF Input)
•
Using the remote control, set the MAGIC mode "ORIGINAL"
•
Activate the adjustment mode display (HSH item). Select HSH item and set its value to adjust the
horizontal symmetry of the pattern;
•
Select HP and HB items and adjust its value if necessary.
3.8 MAGIC Adjustment
•
Adjustment of original magic should have been according to pattern
•
Receive the color bar pattern (NTSC signal, RF input)
•
Connect the oscilloscope probe to the collector of Q830 (cathode G)
•
Using the remote control, set the image controls as follow:
Brightness:
adjust to central position (8 Bars)
Contrast:
adjust from maximum to minimum (4 Bars)
Color:
adjust from minimum to maximum (5 Bars)
Sharpness:
adjust from minimum to maximum (3 Bars)
Tint:
adjust to the center (8 Bars)
•
After the image menu preset, turn off the television and activate the service menu. Select
ORIGMAG item;
17
Advertisement
