Table of Contents
Advertisement
M30 107E2 GS_3
28
Go to cover page
Step 9: Load DDC data
1.
Click
from the tool bar.
2.
Select the file you want to open as shown in Fig. 20.
3.
Click
Open
.
4.
Access "Factory Mode" and enable "Software DDC only" as shown
in Fig. 17 & Fig. 16.
5.
Write EDID (click
).
Step 10: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 21.
(EDID Tool 3.01)
Note1 : In User Mode: Proceed "Read DDC data only"
Before read EDID code, please confirm that the
DDC only was disabled
If you do not disable "Software DDC only", when you execute
"read EDID", it will bring up an error message as below.
Back
DDC Instructions (Continued)
Fig. 20
Fig. 21
Software
as shown in Fig. 22.
Fig. 22
***************************************************************************
Note 2 : In Factory Mode => Proceed "Read/Write DDC data"
Before Read/Write EDID code, please confirm that the
Software DDC only was enabled
as shown in Fig. 23.
Fig. 23
Forward
Advertisement
Table of Contents
