Advertisement
Important
All products must be installed by licensed plumbers.
All pipework must be thoroughly flushed prior to installation, as foreign materials
may block the flow regulating device and reduce the flow of water.
outlet
1.Drill a φ6mm hole at the downwards
outlet vertical downward position
in the recomendation range.
4. Locate and push shower rail
assembly onto wall adaptors.
Tighten grub screws firmly with allen
key provided.
Slide the back plates against the
wall/tile face properly.
www.nerotapware.com.au
G1/2
Apply thread
seal sealant
or teflon tape
2. Screw the adapter onto the outlet.
Push wall plug into drilled hole. Fit
lower mounting pillar in place with
screw. Tighten firmly.
rubber
washer
5.Screw shower head to shower arm
with care. (Note the rubber washer in
the shower head.)
3. Screw shower rail into shower
arm component. Tighten firmly.
Push 2 back plates onto shower arm component
and lower mounting pillar.
rubber
washer
rubber
washer
6. Please noted the rubber washer in the hand
shower.
Connect shower rail and hand shower with hose.
TEST & CHECK FOR LEAKS.
Advertisement
