Table of Contents
Advertisement
8
Feature Overview
OVEN RACK SUPPORTS & OVEN VENTS
Oven Vent Location
The oven is vented under
upper control panel for
the upper oven and
between the doors for the
lower oven. When the oven
is on, warm air is released
through the vent. This
venting is necessary for
proper air circulation in the
oven and good baking
results.
Oven Vent
Warm Air
Installing Standard Oven Rack
OPERATING THE OVEN). Always use oven mitts when using the oven.
To install, take standard oven rack with the handle in front of you and the stoppers looking down. Align the rear of the
rack on the level you want to install it, then push on the rack to slide it in the level until it stops.
This stopper will prevent the rack to bump on
the convection fan cover at the end of its course.
Do not try to install the standard oven rack on the sliders.
Installing Oven Rack Supports
ALWAYS INSTALL OVEN RACK
SUPPORT BEFORE TURNING ON
THE OVEN (WHEN THE OVEN IS
COOL).
To install oven rack support, insert
the supports by pushing them downward
into the two brackets on each side of
the oven interior, as shown below.
To remove the oven rack support for
a self-clean cycle, pull up the support to
disengage them from the brackets. If
the rack supports are not removed, the
self-clean cycle won't start.
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
This "safety stopper" will stop the rack when you pull it out.
This will prevent you to accidentally pull the rack too far and
make it fall.
Removing and Replacing
Extendable Oven Racks
ARRANGE OVEN RACKS WHEN THE
OVEN IS COOL (PRIOR TO
OPERATING THE OVEN). Always use
oven mitts when using the oven.
To remove an oven rack, pull the rack
forward. Lift up the rack off the oven rack
slider. To install an oven rack, locate
the two pinholes in the small plates at
the front corners of the rack. Place the
rack on the side sliders and drop the pin
holes over the pins on the sliders.
Pull oven rack forward and lift
it up off the oven rack slider.
Do not try to install the extendable oven racks
into the standard oven rack levels (or rack support).
Must point
upward
ALWAYS
Installed on sliders
To remove from
sliders
To place on sliders
Advertisement
Table of Contents
