Advertisement
Using a Philips screwdriver, remove the small
tilt range screw from the coupling bracket on
the fan neck and then unscrew the tilt range
knob.
NOTE: It is important that the post and fan
head are in the correct orientation when
assembled.
The top section of the post has a small
horizontal open slot on one side and a small
horizontal depression on the other side as
shown.
Depression
The side with the open slot is for the small tilt
range screw. The side with the small
depression is for the tilt range knob to tighten
up onto.
Take the head assembly and position the
mating section over the post end as shown.
Depression
this side
Assembly (cont.)
Slide the tilt adjustment bolt all the way
through as shown.
Screw in the tilt range knob to loosely secure.
Using a Philips head screwdriver, screw in the
small tilt range screw and tighten.
Open slot
Screw on the tilt adjustment knob and tighten.
Advertisement
