Table of Contents
Advertisement
Available languages
Available languages
GB - Table of Contents
Illustrations ................................................................... 2
Warning symbols .......................................................... 5
Safety precautions ....................................................... 8
Identification of parts .................................................... 8
Adjustment ................................................................... 8
Mounting ...................................................................... 8
Use ............................................................................... 8
Change of brush ........................................................... 9
Storage......................................................................... 9
Specifications ............................................................... 9
Warranty terms and conditions ..................................... 9
EC Certificate of conformity ........................................ 10
Spare parts
Spare part drawings for the specific product can be
found on our website www.texas.dk
If you find the part numbers yourself, this will facilitate
more rapid service.
For purchase of spare parts, please contact your
dealer.
You will find a list of dealers on the Texas website.
Because of continued product development Texas A/S
reserves the right to improve the product without
obligation to improve already sold models.
Safety precautions
When using the product, the safety instructions must be
closely followed. Read this manual carefully before
starting the machine. Make sure that you know how to
stop and switch off the engine in case of accident. All
instructions regarding safety and maintenance of the
machine are for your own safety.
The warnings, precautions and instructions given in this
manual, cannot cover all situations that the product can
be placed in. The user must therefore present common
sense and caution when using the product.
Safety in the work area
•
Only use the product in clean and well lit areas
•
Do not use the product in areas with explosive
danger or where there is flammable fluids, gas or
dust present.
•
The person that uses the machine is responsible to
other persons in the work area. Never use the
machine when others, especially children or
animals are near.
•
This product is an electric product. It is therefore
important, that it is never in contact with water or is
used in wet surroundings.
Use and maintenance of the product
•
A product must not be used for other work than as
described in this manual.
•
Only use original spare parts. Mounting of non-
approved parts may lead to increased risk and are
therefore not legal. Any liability is renounced for
accidents or other damage that has happened due
to the use of unauthorised parts.
•
Before using the machine, the dealer or other
qualified person should instruct you in the use of
the machine.
•
Minors may not work the machine.
•
The machine may only be lent to people who know
how to work the machine. This manual should
follow the machine under all circumstances.
•
The product may only be used by persons who are
rested, well and fit. If the work is tiring, frequent
brakes should be made. Do not use the machine
under influence of alcohol.
•
Always check before start, that all bolts and nuts
are tigthened.
•
Always wear eye protection when using the
machine.
•
Keep children and other persons at a distance of at
least 5 metres from the work area.
Use original spare parts/accessories only
Identification of parts
Figure 1
1.
On/Off switch
2.
Front handle
3.
Release bracket
4.
Telescopic shaft
5.
Motor housing
6.
Release button
7.
Speed adjustment
8.
Sweeper unit
9.
Brush ring
Adjustment
Figure 2
Set the front handle in desired position by loosening the
lock screw (A), adjust the position and tighten again.
Figure 3
Se the length of the telescopic shaft in the desired
position by loosening release bracket (A), adjust the
length and tighten again.
Mounting
This machine comes with 2 working heads.
See Figure 5:
A.
A wide brush, which can be used to clean surfaces
like a wooden terrace.
B.
A slim brush to remove weed between the pavers.
Mount the working head by following the steps shown in
Figure 4.
To dismount the working head, press the release button
in front of machine down, while the head are turned
clockwise.
Use
Always test the brush a less visible place before it
is being used!
Use the wide brush on flat surfaces, e.g. terrace
boards, combined with water and suitable soap. Always
work along the wooden boards, never across.
Figure 6
Use the slim brush to remove moss and smaller weeds
between flagstones and pavers The nylon brush (A) is
more gentle to the pavers, while the steel brush (B) is
8
Advertisement
Table of Contents
