Homa HDH-20T33 Instruction Manual page 13

4. Timer
5. Fan speed button
6. Lock button
7. Digital Display
Power button
In the standby state, Touch this button to turn on, the operation indicator lights up and the default fan speed is high, and
the default humidity is 50%. In the power-on state, Touch this button to turn off, the running indicator light goes off and the
compressor stops immediately, and then the fan shut down after 30 seconds delay.
Mode button
Touch the mode key to switch between automatic,Sleep and dry mode.
Automatic mode: when environmental humidity ≥ set humidity +3%, the fan starts working and compressor starts working
after 3 seconds.
When environmental humidity ≤ set humidity -3%, the compressor stops working and fan stops working after 30 seconds'
delay.
Touch HUM" " button button to adjust the humidity level in automatic mode.
Both fan speed and humidity can be adjusted under auto mode.
Drying mode: The compressor keeps working without control by humidity; Fan speed can be adjusted, but target humidity
level cannot.
Sleep Mode: Touch the sleep button, the button lights up and start the sleep function.After no operation in 10 seconds, all
indicators turn dark gradually and the wind speed is automatically switched from high to low, press any button to wake up
the indicator. Touch sleep button again to exit the sleep mode.
Timer button
Touch the timer button to set the 00-24 hour timing function. Display panel
"88 "flashes and will show timer hour, Touch HUM"
display screen.
In the running state, use the timer function to turn off the machine regularly".
In the standby state, use the timer function to turn on the machine regularly".
Set the time to "00" to cancel the timing function.
Speed
High wind - low wind cycle, Touch the button once to switch and then the corresponding indicator lights up. In continuously
drying mode, sleep mode and defrosting period, the wind speed cannot be changed.
Child lock
Long press the child lock button to turn on or off the child lock function.
DRAINAGE
Water Tank Full Alarm
Water Tank Indicator
• When the tank is full for 5 seconds, it sets the alarm. The water tank indicator turns red and the unit buzzes for 5 times.
Clear the alarm
EN:
DEHUMIDIFIER
Touch this button to set a time for the unit to automatically start or stop.
Touch this button to select fan speed between high and low.
Hold this button to turn child lock function on or off.
Displays humidity value, Timer setting or Temperature.
" button, the value increase 1 hour, the value displayed on the "88"
| Instruction Manual
13