Advertisement
5.2.
using tHe bead seateR in tHe HoRiZontal position.
5.2.1.
Adjust the barrel, so that the barrel flange is on the top, ensuring that it is secure.
5.2.2.
ensure that both beads of the tyre have been well lubricated and position the wheel on to a stand. the valve stem should be pointing
upwards and the wheel should be off the ground so that the lower bead should be already seated.
5.2.3.
Position the bead seater so that the weight of the unit is resting firmly and comfortably on your leg, and rest the barrel flange on
the rim of the wheel directly opposite the valve stem. Attach an air line to the valve stem to simultaneously assist in the inflation process.
the bead seater should be positioned at an angle of between 50 and 70 degrees (fig.1), so that the barrel is pointing directly into the
largest gap between the tyre and the wheel (fig.3).
5.2.4.
Holding the bead seater securely with one hand and keeping it steady against the wheel quickly open the release valve with the other
hand. if the bead does not seat, recharge the tank to a higher pressure and repeat the procedure.
note: once the bead has been set, if required, move the wheel into a tyre cage and inflate to the manufacturers recommended
pressure.
5.3.
using tHe bead seateR in tHe upRigHt position (tRuCK tYRes onlY).
5.3.1.
Adjust the barrel so that the barrel flange is on the bottom, ensuring that the lock nut holding it is secure.
5.3.2.
Position the wheel against a wall or a solid prop. make sure that the valve stem is at the bottom and facing towards you.
5.3.3.
Attach an air line to the valve stem to simultaneously assist in the inflation process.
5.3.4.
the bead seater should be positioned at an angle of between 50 and 70 degrees (fig.2), so that the barrel is pointing directly into the
largest gap between the tyre and the wheel (fig.3).
5.3.5.
Holding the bead seater securely with one hand and keeping it steady against the wheel quickly open the release valve with the other
hand. if the bead does not seat, recharge the tank to a higher pressure and repeat the procedure.
note: once the bead has been set, if required, move the wheel into a tyre cage and inflate to the manufacturers recommended
pressure.
WaRning! Always wear the personal safety equipment as recommended in these instructions whilst using this product.
‰
fig.1
fig.1
fig.3
enViRonMent pRoteCtion
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey group, Kempson Way, suffolk business park, bury st edmunds, suffolk. ip32 7aR
01284 757500
© Jack sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.2
www.sealey.co.uk
tc900.V2 issue 1 22/01/18
Advertisement
