Stealth Cam STC- ZX36NG Instruction Manual page 14

o
TIME LAPSE: In this mode the camera will take a designated amount of pictures with a
designated time out between the designated hours of operation even if there is no
activity in front of the camera.
"
PHOTO RES – 6.0 MP (default): This setting is used to determine the Megapixel resolution of
each image taken by the camera. With this option blinking, use the UP or DOWN arrow key
to move between the options of: 10MP, 6MP, 4MP and 2MP. The higher the resolution of an
image the more space the file will take on the SD memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time
that the camera will wait before it reinitializes its PIR sensor for the next activation. With the
TL mode this setting is only active if TL Delay is set to 1 min or greater. This setting can be
changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking,
use of the UP and DOWN arrows will allow the minutes setting to be changed from 00 to
59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to
the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds setting to be changed from 05 to 59 (05 to 59 if minutes = 00).
"
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE
images. This setting can be changed between the numbers of 00min 05sec to 59min
59sec. With this option blinking, use of the UP and DOWN arrows will allow the minutes
setting to be changed from 00 to 59. Once this setting is on the appropriate minutes, press
the RIGHT arrow key to move to the seconds setting and it will start to blink. Use of the UP
and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if
minutes = 00). If the TL Delay is greater than or equal to 1 min, then the PIR sensor will be
active between time-­‐lapse photos.
"
TL START – 06:00PM (default): This setting is used to give the camera the start time for when
to start the time-­‐lapse photography. The default format is in a HH/MM/AP setup, should the
time format be in 24 hour the format will show HH/MM. With the HH (hour) setting blinking,
use the UP and DOWN arrows to allow the setting to be changed from 1 to 12.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
14