Table of Contents
Advertisement
f
Pass the thread through the thread guide.
1 Thread guide
g
Pass the thread around the pretension disk making sure
that the thread is under the pretension disk.
Pull the thread as far as possible.
a
1 Pretension disk
2 Thread guide
h
g
Follow steps
through
page 26.
a
j
on page 25 through
WINDING/INSTALLING THE BOBBIN
Setting the Bobbin
CAUTION
• Use a bobbin that has been correctly wound
with thread, otherwise the thread tension may
be incorrect and the needle may break,
causing injuries.
• Before inserting or changing the bobbin, be
sure to touch
and buttons. Otherwise injuries may occur if
the "Start/Stop" button or any other button is
pressed and the machine starts embroidering.
a
Touch
to lock all keys and buttons and raise the
presser foot.
*
If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
to continue.
b
Slide the bobbin cover latch to the right and remove
the bobbin cover.
c
Insert the bobbin into the bobbin case so that the
thread unwinds to the left.
d
Lightly hold down the bobbin with your right hand,
and then guide the end of the thread around the tab of
the needle plate cover with your left hand.
a
Note
• Be sure to hold down the bobbin with your finger
and unwind the bobbin thread correctly, otherwise
the thread may break or the thread tension will be
incorrect.
in the LCD to lock all keys
1 Tab
1
27
Advertisement
Table of Contents
