Table of Contents
Advertisement
(7) Following the screen indication, set up the sub motor hook position.
After the completion of setting, press the
(8) Press the home position return icon
press the
on the standard screen. Turn the hand pulley by hand and make sure the timing
between hook and needle motion is performed sufficiently as described above.
(9) After adjustment turn the power switch off.
(10) After adjustment, put the sliding plate and bobbin case to the original locations and close the bobbin
access door.
(11) When put the sliding plate back on the sewing machine, in order for the needle (No.1) to come into
the right center of the needle hole of the needle plate (No.2), make sure that the needle plate hole
center matches with the needle point then, tighten the set screws.
<1>
icon and then press the
. After completing the origin return operation,
<2>
<1>: Needle
<2>: Center of the needle hole
- 21 -
icon.
Advertisement
Table of Contents
