Honeywell HWDT-620W Owner's Manual page 5

SET-UP/PRODUCT OPERATION
BEFORE PLUGGING IN THE UNIT TO A POWER SOURCE
WARNING: Before plugging in the unit, make sure to have poured water from the hot water faucet. IF THE
DISPENSER IS TURNED ON WITH AN EMPTY WATER TANK IT CAN BE DAMAGED.
1. Let the appliance stand upright for about 24 hours. This will reduce the chance of malfunction in the
cooling system from possible mishandling during delivery.
WARNING: The drain cap on the back of the unit may become loose during shipping. Fasten the drain cap
tightly before you start to operate the unit. If the drain cap is loose, the unit may leak and cause floor
damage.
2. Insert water bottle vertically through the water funnel.
3. Place a container under the hot and cold water faucets then push down both buttons to test if water is
flowing through the unit. To use the hot water, first press the hot water safety button.
4. Insert the power plug into the wall socket.
5. First, turn the hot water switch on the back of the unit into the ON position. Next, turn the cold water
switch into the ON position. DO NOT TURN ON BOTH SWITCHES AT THE SAME TIME. Once this is
completed both cooling and heating indicator lights should light up.
NOTE: The appliance is designed to provide hot or cold water whenever you need it. It will automatically
turn on and off when hot and cold water reaches the desired temperatures.
When operating the water dispenser for the first time, you will need at least 15-30 minutes for the hot
water to reach the desired temperature and 1 hour for the cold water to reach the desired temperature.
The water dispenser has 3 indicator lights on the front panel.
•
When the right (icon) indicator light is on, the unit is in the process of cooling water inside the cold
water tank.
•
When the left (icon) indicator light is on, the water dispenser is heating water inside the hot water tank.
•
When you plug the water dispenser in, the middle (icon) indicator will be turned on. This means that
room temperature water can be dispensed.
Using the water dispenser
•
To dispense hot water, press the hot water safety button and then push the hot water button down.
•
To dispense cold water, push the cold water button down.
•
To dispense room temperature water, push the room temperature button down.
•
To use the Cold Water Temperature Regulator, turn the knob clockwise to get colder water and turn the
knob counter-clockwise to get warmer water. The default temperature is 45˚F.
•
It is recommended that if the hot water option is not used, the hot water button (red switch) be turned
OFF. This will help conserve energy.
5