CARTON CONTENTS
The following parts are shipped loose with your pressure
washer:
•
Main Unit -- pressure washer with wheels and guide
handle
•
Product IntroductionVideo
•
Nozzle Cleaner Kit
•
High Pressure Hose
•
Parts Box (which includes items listed below
•
Spray Gun
•
Wand Extension with Hi-Lo Adjustable Nozzle
•
Wire Form
•
Motor Oil
Become familiar with each piece before assemblingthe
pressure washer. Check all contents against the illustra-
tion on Page 6. If any parts are missing or damaged, call
the Pressure Washer Helpline at 1-800-222-3136.
TOOLS REQUIRED FOR ASSEMBLY
2 adjustable wrenches OR the following wrenches
•
11/16" (17mm) wrench
•
7/8" (23mm) wrench
TO REMOVE PRESSURE WASHER
FROM
CARTON
Remove loose parts and parts box included with pres-
sure washer. The high pressure hose is packed in the
bottom of the carton on the guide handle end.
Remove the hose.
•
Slice two corners at guide handle end of carton from
top to bottom so the panel can be folded down flat,
then remove all packing material.
•
Raise guide handle and secure in place.
Loosen knobs to
raise handle
,/
•
Remove the unit by rolling it out the opening in the
carton, then check carton for additional loose parts.
HOW TO SET UP YOUR PRESSURE WASHER
For the most part, your Craftsman High Pressure Washer
has been assembled at the factory. You must, however,
attach the wire form, assemble the spray gun, and attach
the high pressure hose to the pump and spray gun.
Note: Included with your unit is a video cassette that
demonstrates how to set up your pressure washer. If
you have a viedo cassette recorder you may wish to view
the video before assemblingyour unit.
•
Insert the wire support with the longer arm positioned
on the left. From this view the hook should resemble
a "J".
LONG
ARM
SHORT
ARM
Cut lie wrap on chemical injection tube. Remove chemi-
cal injection filter, threadchemical tube through the wire
form and reinsert filter into tube.
Tighten knobs
when handle
straight.