Philips 55PFL5505D/F7 Service Manual page 43

Power Supply Schematic Diagram
CAUTION !
Fixed voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F1) is blown , check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
CAUTION ! : For continued protection against risk of fire,
replace only with same type 5 A, 250V fuse.
5A/250V
ATTENTION : Utiliser un fusible de rechange de même type de 5A, 250V.
10-16
NOTE:
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
PL10.8SCP