Removing And Inserting The Oven Door Glass Pane - Hisense HG51011BS Instructions Manual

Removing and replacing the oven door
(depending on the model)
1. Open the oven door (up to end position).
2. Raise up and turn the flaps.
3. Slowly close the oven door, lift it slightly and pull
it out from the both hinges of the appliance.
Provide these steps in reverse order at
returning the door back. If the door does not open or
close properly, make sure, that the hinges are
correctly located on their hooks.
REMOVING AND INSERTING THE OVEN
DOOR GLASS PANE
Oven door glass pane can be cleaned from the
inside, but it has to be removed first. Remove the
oven door (see chapter "Removing and replacing the
oven door".
Slightly lift the supports on the left and right side of
the door (marking 1 on the support) and pull them
away from the glass pane (marking 2 on the
support).
EN
(depending on the model)
Hold the door glass pane by the lower edge; slightly
lift it so that it is no longer attached to the support;
and remove it.
To remove the third glass pane (only with some
models), lift and remove it. Also remove the rubber
seals on the glass pane.
To replace the glass pane, observe the
reverse order. The markings (semicircle) on the door
and the glass pane should overlap.
Removing and inserting the oven door
glass pane
(depending on the model)
Screw out the screws on the door left and right sides
and pull out the upper lath. You can pull out the glass
pane of door now.
Provide these steps in reverse order at
returning the glass pane back.
13