Yamaha MT09SPN Owner's Manual page 28

Instrument and control functions
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
5
set this switch to "
the switch down towards " ". See
page 7-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
used in case of an emergency or to
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
The hazard lights can be turned on or
off only when the key is in the "ON" po-
sition. You can turn the main switch to
the "OFF" or "LOCK" position, and the
EAU66030 hazard lights will continue to flash. To
turn off the hazard lights, turn the main
switch to the "ON" position and oper-
ate the hazard switch again.
EAU66061
/ / "
NOTICE
", and then push Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
" to stop the en-
Cruise control switches
See page 4-1 for an explanation of the
cruise control system.
EAU91670
MODE switches
Use the MODE switches to change the
"D-MODE" and "TCS-MODE" located
on the left side of the main display.
There are three mode controls:
MODE up switch - push this switch to
change the selected mode setting up-
ward.
"MODE" switch - push this switch to
toggle left to right between "D-MODE"
and "TCS-MODE".
MODE down switch - push this switch
to change the selected mode setting
downward.
TIP
 When in "D-MODE 1", pressing
ECA10062
 The "TCS-MODE" can only be
EAU73952
 To turn the traction control system
EAU91364
 When "TCS-MODE" has been set
 See page 5-9 for more information
5-3
the MODE up switch will cycle to
"D-MODE 4". When in "D-MODE
4", pressing the MODE down
switch will not cycle to "D-MODE
1".
turned off from the main display.
Select "TCS-MODE" with the
"MODE" switch, then push and
hold the MODE up switch until
"OFF" is displayed.
back on, use the MODE down
switch.
to "OFF", the traction control sys-
tem, SCS and LIF systems are all
turned off together.
on the MODE display.