Gainsborough K340 Quick Start Manual

Set 2 Bloom Illuminating Solar Lights
K340
v001: 31/12/21
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set switch (located on the back of solar case) to "ON" position. Charge the solar product by placing it
under direct sunlight for at least 8 hours.
2. The light will work automatically. It will charge under direct sunlight during the daytime and
illuminate at night.
3. Leave the switch to "ON" position.
NOTE: In order to test the lights simply cover the solar panel with your hand and the light should turn on
automatically.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
To easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging garden
stakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake first
ALWAYS POSITION IN DIRECT SUNLIGHT
Dimensions
Height 50cm,spacing 50cm
•
2 X 2 FLEXIBLE LIGHTS TO DIRECT LIGHT ON THE
PLANTS
•
POLYCRYSTALLINE SOLAR PANEL
•
LEAD WIRE FROM LIGHTS TO SOLAR PANEL:
100CM
•
WARM WHITE LED INSIDE EACH HEAD
•
SOLAR POWERED, AUTOMATICALLY TURNING
ON/ OFF AT DUSK AND DAWN
Batteries Required: 1x AA 1.2v 400Mah, Ni-MH,
Rechargeable (Included)