Download Print this page

Gainsborough K419 Quick Start Manual

Spiral solar lights

Advertisement

Quick Links

Spiral Solar Lights
K419
v001: 10/11/21
Please read and retain these instructions for future reference
Always position in direct sunlight
BEFORE FIRST USE: Remove the protective film from the solar panel.
HOW TO USE THE SOLAR LIGHT
1. Install the light in a sunny location with full, direct sunlight. Shady locations may not allow the battery to
fully charge and will reduce the hours of performance during the night.
2. Remove the top of the solar light, and turn over to locate ON/OFF switch.
3. Push the ON/OFF switch to the "ON" position to activate the device.
4. Charge in direct sunlight for 6-8 hours.
5. The LED will turn on automatically at night.
6. Push the ON/OFF switch to the "OFF" position to deactivate the device.
NOTE: In order to test the lights simply cover the solar panel with your hand and the light should turn on
automatically.
IMPORTANT:
1. Install the solar product in an area where it can get direct sunlight.
2. Leave the switch in the ON position.
3. Select an outdoor location away from other light sources at night, such as street lights. It may cause the
product not to turn on automatically at night.
4. Duration of light depends on solar product's level of sunlight exposure, geographical locations, weather
conditions and the hours of daylight.
BATTERY REPLACEMENT
1. Remove the upper part of the body that is pushed into the main housing and turn over the unit.
2. Remove the screws and lift the battery cover off the body taking care not pulling any wires. Note the
polarity that the battery is fitted.
Dimensions
16cm diameter
Material
Metal
Each solar light contains 20pcs micro warm white non-
replaceable LED.
Battery
Battery 1x AAA 1.2v 150Mah, Ni-MH, Rechargeable
THESE SPIRAL LANTERNS COME AS A PACK OF 3 WITH A
RED, WHITE AND BLUE COLOUR IN EACH PACK
EACH LANTERN IS SCATTERED WITH WHITE LEDS THAT
LOOK MAGICAL WHEN LIT UP
WITH A METAL HANGING HOOK YOU CAN HANG THEM
FROM TREES, BRACKETS ETC TO CREATE A STUNNING
SHOW AT NIGHT
SOLAR POWERED
AUTOMATICALLY COMES ON AT NIGHT
.

Advertisement

loading

Summary of Contents for Gainsborough K419

  • Page 1 Spiral Solar Lights K419 v001: 10/11/21 Please read and retain these instructions for future reference Dimensions 16cm diameter Material Metal Each solar light contains 20pcs micro warm white non- replaceable LED. Battery Battery 1x AAA 1.2v 150Mah, Ni-MH, Rechargeable •...
  • Page 2 Spiral Solar Lights Instructions for Use K419 Please read and retain these instructions for future reference v001: 10/11/21 3. Remove the battery, replace with a new 1.2V 2/3 AAA 150MAH Ni-MH rechargeable battery according to the polarity symbols. 4. Put the battery cover back in place.