Advertisement
2. Installation
Cable Manager Locking Details
4. After positioning the cable manager into
the table cut-out, insert the mounting clamp
to the enclosure for securing the unit to the
table surface (on both sides)
After installing the cable manager on the table
Ensure the mounting clamps has been assembled as per above instruction (on both sides)
5. Softly tighten the screw to
secure the enclosure towards
the bottom side of the table
(on both sides)
Table Surface
Bottom side
of the table
www.logicav.in
INSTALLATION MANUAL
CABLE MANAGER
MODEL
SERIES
LC-404-N19 CABLE CUBBY SERIES
www.logicav.in
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Logic LC-404-N19
Summary of Contents for Logic LC-404-N19
- Page 1 (on both sides) After installing the cable manager on the table Table Surface Bottom side of the table MODEL SERIES LC-404-N19 CABLE CUBBY SERIES Ensure the mounting clamps has been assembled as per above instruction (on both sides) www.logicav.in www.logicav.in...
- Page 2 Checklist 2. Installation Instruction to provision the cut-out on the table: ATTENTION: The cut-out on the table for the cable cubby should be executed only by an experienced craftsperson to prevent any damage/scarring CAUTION: Wear safety glasses while operating power equipment. Failure to comply may result in eye injury Lorem ipsum B: Mounting...
Need help?
Do you have a question about the LC-404-N19 and is the answer not in the manual?
Questions and answers