Checklist A: Cable Retractable B: Screw x 4 Module x 1 (Extra Screw x 1) 1. Installation 1. Use L-clamp and screws 2. Position the L-clamp as shown in the 2 nos from LG-805RC image and then, screw them softly (Refer screw B in the module checklist) www.logicav.in...
Page 5
View after positioning the L-clamp with modules www.logicav.in...
Page 6
3. Insert the modules into the enclosure from the bottom side of the table www.logicav.in...
Page 7
4. Mount the L-clamp (along with modules) to the enclosure with screws (Refer screw D in the LG-805RC checklist on both slots and module) www.logicav.in...
Page 8
5. Pull the cable from the retractor and place it in the C-shape cut out (Refer C-shape plate H in the LG-805RC checklist) Further, position it on the enclosure Reference image for 3 x Modules and 1 x Blank plate (Refer blank plate G in the LG-805RC checklist) www.logicav.in...
Page 9
6. Position and softly tighten the screw (8 no’s) as per the previous point (Refer screw E in the LG-805RC checklist) www.logicav.in...
Page 10
Top view of the cable manager with three modules and one blank plate Isometric view Table Final view reference image www.logicav.in...