Table of Contents
Advertisement
The operating water pressure at the water entry point
•
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 10 bar (1.0 MPa).
The appliance maximum load is 10 kg. Do not exceed
•
the maximum load of each programme (refer to the
"Programmes" chapter).
The appliance must be connected to the water mains
•
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Items that have been soiled with substances such as
•
vegetable or mineral oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax
removers should be washed separately with an extra
amount of detergent before being dried in the washer
dryer.
Do not use the appliance if items have been soiled
•
with industrial chemicals.
Do not dry unwashed items in the wash dryer.
•
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, and rubber backed articles and
clothes, or pillows fitted with foam rubber pads should
not be dried in the washer dryer.
Fabric softeners, or similar products, should only be
•
used as specified by the product manufacturer's
instructions.
Remove all objects from items that could be a source
•
of fire ignition such as lighters or matches.
WARNING: Never stop the washer dryer before the
•
end of the drying cycle unless all items are quickly
removed and separated so that residual heat can
dissipate.
ENGLISH
5
Advertisement
Table of Contents
