[Network Settings]; [Ip Program Settings] - NEC Slot-in Tuner (DVB-T, Analogue, IPTV) STv1 User Manual

[Network Settings]

This module will automatically attempt to establish a network
connection using DHCP when an active network cable is
connected, or can be manually configured to use a static
IP address. (Contact your network administrator to acquire
the correct values for each parameter before making the
changes.)
[DHCP]
1. On the [Network Settings], press
[DHCP], then press [SET] button. You will see [DHCP]
menu.
2. Select [Yes], then press [SET] button to connect.
(To confirm a successful connection, select [System
Information] on the [System] menu page to check for the
presence of an IP address.)
3. Press [OPTION] or [EXIT] button to leave this window.
[Static IP]
1. On the [Network Settings], press
IP], then press [SET] button.
2. Press the numeric buttons to enter the IP Address [IP],
Subnet mask [Netmask], [Gateway] and [DNS] parameters.
When finished, select [Done], then press [SET] button to
manually implement the network settings.
3. Press [OPTION] or [EXIT] button to leave this window.

[IP Program Settings]

1. On the [Tuner] menu page, press
Program Settings], then press [SET] button.
2. Select [Add], then press [SET] button. There are two sub-
menus are listed.
(1) [Unicast]
Press button to select [Unicast], then press [SET]
button, you will see the [Channel No.] and [Port] to be
typed. Select [Add], then press [SET] button to apply.
(2) [Multicast]
Press button to select [Multicast], then press [SET]
button, you will see the [Channel No.], [IP Address]
and [Port] to be typed. Select [Add], then press [SET]
button to apply.
3. Select [Delete] on the step 2 above, then press [SET] button,
you can type the [Channel No.] to delete the IP channel
program.
4. Press [OPTION] or [EXIT] button to leave this window.
button to select
button to select [Static
button to select [IP
English-8