Related Manuals for Garnet 4G-MAX-G
Summary of Contents for Garnet 4G-MAX-G
- Page 1 WIFI / 4G / 3G / 2G COMMUNICATOR Installer's Manual 4G-MAX-G ENGLISH www.garnet.com.ar...
-
Page 2: Table Of Contents
INDEX Information General The 4G-MAX-G communicator is designed to report events via three communica- Page tion paths: General Information ...................... 1) Internet connection via a Wifi network Technical Specifications ....................2) Internet connection using mobile data service 3) Sending text messages using the cellular service (SMS) Description of the Module .................... -
Page 3: Description Of The Module
Panel control modes: The 4G-MAX-G communicator allows control of the panels via two methods, one method is by using the Garnet Control application, and the other method is via text messages or SMS. Compatible panels: The 4G-MAX-G communicator is compatible with the Garnet and DSC panel families. - Page 4 Light indications of states The 4G-MAX-G communicator incorporates a variety of LEDs to indicate different communicator statuses. Figure 2 - DSC mode of operation: LEDs indicate the signal strength of the Wi-Fi network, the Mobile Data network and the results of the reports to the server and the monitoring station.
-
Page 5: Programming The Communicator And Panels From The Garnet Programmer App
2) Search your phone for available WiFi networks and connect to the WiFi network whose name is “4G-MAX-Gxxxxxx”. XXXXXX being the last 6 digits of the communi- In order to configure the Garnet alarm panels via the communicator, the commu- cator mac. - Page 6 Once the application is downloaded to your mobile phone, it is imperative that you activate the “Airplane” mode on your mobile phone, or switch off mobile data Note: The Garnet Control application allows up to 20 total users to be associated. transmission.
- Page 7 3) Enter the default network password: admin1234 . Note: The Garnet Control application allows up to 20 total users to be associated. 4) Once the communicator enters programming mode. The LEDs will behave as follows Each user that registers in the app can have a different user code that must be previously loaded in the alarm panel.
-
Page 8: Communicator Reset
The possible parameters for the Inhibit and Uninhibit commands are as follows: z01, z02, z03, z04, z05... z32 Control of the panels with the 4G-MAX-G communicators can be done via mobile data, but if the communicator does not have Internet because the chip does not... -
Page 9: Notes
NOTES NATIONAL WARRANTY: Alonso Hnos. Sirenas S.A. (Garnet Technology) warrants to the original purchaser that, for a pe- riod of 18 months from the date of purchase, the product is free from defects in materials and workmanship under normal use. During the warranty period, Alonso Hnos Sirenas S.A., decides whether to repair or replace any defective product. - Page 10 DISCLAIMER OF WARRANTIES: This warranty contains the entire warranty and shall prevail over all other warranties and all other warranties, whether expressed or implied (including all warranties implied on the goods or intended for a particular purpose) and all other obligations or liabilities on the part of Alonso Hnos. Sirenas S.A., who neither assumes nor authorizes any other person to act on its behalf, to modify or change this warranty, nor to assume any other warranty or liability concerning this product.