Samsung Galaxy S20+ User Manual page 44

Getting started
Tools
The Tools panel provides handy instruments for quick access.
1. From any screen, drag the Edge handle to the center of the screen. Swipe until
the Tools panel is displayed.
2. Tap a tool to use:
• Compass: Identify compass directions.
– Tap Calibrate to calibrate the compass.
• Tally counter: Use the plus and minus icons to add or subtract while counting.
– Tap Vibration to enable or disable vibrations with each addition or
subtraction.
– Tap Target to set a total target number between 1 and 9999.
– Tap
• Flashlight: Tap
and minus icons to increase or decrease the brightness of the light.
– Tap SOS to make the flashlight signal the phrase "SOS" in Morse code.
• Surface level: Use the device to determine if a surface is level by placing the
device on the surface. The surface is level when the x and y values are close
to or equal to zero degrees.
– Tap Calibrate to calibrate the level.
• Ruler: Use the edge of the device as a ruler to measure a straight line in
either inches or centimeters. Tap the unit name to change the units.
Configure Edge panels
You can customize the Edge panels.
1. From the Edge screen, tap
2. Tap to enable the feature. The following options are available:
Checkbox: Enable or disable each panel.
•
• Edit (if available): Configure individual panels.
Search: Find panels that are either installed or available to install.
•
Reset to reset the counter.
Flashlight to turn the flashlight on and off. Use the plus
Settings.
43