Nabis A05017 Instructions Manual page 4

Mono basin mixer
Tap body
Anti-rotational washer
Fixing rod
C shaped rubber washer
C shaped metal washer
Fixing Nut
Flexible tails
1. Identify all components and check for completeness, particularly before commencing installation.
2. Screw fixing rods to tap body and tighten it.
3. Ensuring that the anti-rotational washer is fitted between the tap body and the sink.
4. Screw 2x flexible tails into the tap body. Do not over tighten.
5. Locate the tap assembly down through the tap hole in basin.
6. Slide the C shaped rubber washer and the C shaped metal washer onto the fixing rod up to the underside of the basin.
To secure the mixer in place tighten the fixing nut onto the fixing rod until they fully tightened against the C shaped metal
washer. A suitable spanner may be required to fully tighten the fixing nuts.
7. Connect the flexible tails to the hot and cold water supplies.
8. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.
9. Check all joints and connections for any leaks.
Basin / Bath tap
Tap Body
Anti-rotational washer
Backnut
1. Identify all components and check for completeness, particularly before commencing installation.
2. Remove backnut from tap tails.
3. Fit the tap body through the holes in basin/bath, ensuring that the Anti-rotational washer is fitted between the tap body and the
basin / bath.
4. Secure the tap body to the basin / bath using the backnut below the basin/bath. Tighten the backnut onto the threaded tails.
A suitable spanner may be required to fully tighten the backnut.
5. Connect the hot and cold water supplies to tap body.
6. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.
7. Check all joints and connections for any leaks.