Operation - Electrolux EHG6832X Instruction Booklet

Operation

Hob burners control knobs Hob burners control knobs
Hob burners control knobs Hob burners control knobs Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners Lighting the burners
Lighting the burners Lighting the burners Lighting the burners
For easier lighting, For easier lighting, For easier lighting,
For easier lighting, For easier lighting,
putting a pan on the pan support. putting a pan on the pan support. putting a pan on the pan support. putting a pan on the pan support. putting a pan on the pan support.
To light a burner:
turn the relevant knob anticlockwise to
maximum position (
down to ignite the burner.
Only for models EHG 641, EHG 6412,
EHG 6832
Upon ignition, keep the knob pushed
down about 5 seconds
the "thermocouple" (Fig. 1 - letter D) to be
heated and the safety device to be
switched off, otherwise the gas supply
would be interrupted.
Then adjust the flame as required.
If the burner does not ignite, turn the
control knob to zero, and try again.
When switching on the mains, after
installation or a power cut, it is quite
normal for the spark generator to be
activated automatically.
In the absence of electricity, ignition can
occur without the electrical device; in this
case, approach the burner with a flame,
proceed before proceed before proceed before
proceed before proceed before
), then push it
5 seconds. This will allow 5 seconds 5 seconds
5 seconds
electrolux 9
Triple Crown Burner (only
in mod. EHG 6832)
C
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple (only in models
EHG 641, EHG 6412, EHG 6832)
A
B
D
Fig. 1