Attach Front Grille To Cabinet - LG LT12124CNR Owner's Manual

7
To achieve rearward slope for unit draining,
remove the backing from the 11-13/16 " shim
strips and attach them as shown below in
Figure 22. The higher portion of shim is to be
placed in front of the rib on the base of wall
sleeve.
1" high
6"
8
Install the new unit into the wall sleeve.
9
Assemble trim as described in Step 5,
Procedure A.
CAUTION
• Air Conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the Air Conditioner, be careful
to avoid cuts from sharp metal fins on front and
rear coils.
• Make sure Air Conditioner does not fall during
removal.
• If unit does not operate after installation check,
to be sure the circuit interrupter has not been
tripped. Refer to the Troubleshooting guide for
reset procedure.
16
3
/ " High
4
Figure 21
Shim (2EA)
6"
Figure 22
Attach Front Grille to
Cabinet
The front grille can be removed for cleaning or to
check the model and serial numbers.
For your safety, you should attach the front grille
as the following procedures.
1
Pull down front grille from the cabinet top.
2
Push front grille's tips toward the cabinet
in order to insert front grille's tabs into the
cabinet.
3
Open the inlet grille. Tighten the screw through
the front grille into the plate of control box.
4
Close inlet grille.
EN