Advertisement
STEP 1: Vehicle Prep
1.1 Remove and save the Slow Moving Vehicle (SMV) sign
and bracket (see Figure 1.1).
1.2 Unplug and remove the round directionals from the rear
of the vehicle (see Figure 1.2).
1.3 Unplug and remove the optional work lights and brackets
(if installed) from the ROPS at the rear of the vehicle (see
Figure 1.3).
1.4 Remove and retain the front floor mat (see Figure 1.4).
Upon reinstallation at a later step, the floor mat will need
to be trimmed to fit around the cowl and several
alignment knobs will need to be removed.
1.5 Remove the rear backhoe floor panel from the hinge pins
and cut in line with the edge as shown in Figure 1.5. Use
a paint marker to cover the cut edge and re-install.
Front Floor Mat
Figure 1.4: Remove the Front Floor Mat
Continue Edge
Through Panel
Figure 1.5: Trim Rear Floor Panel
INSTALLATION
Figure 1.1: SMV Sign And Bracket
Figure 1.2: Remove Rear Round Work Lights
Figure 1.3: Remove Optional Rear Work Lights
6 of 37
Advertisement
