Table of Contents
Advertisement
15 Introduction
Network connector and reset button
2.3 Pairing – Establishing a
Powerline connection
devolo Magic adapters that are in the factory de-
fault condition, i.e. have been recently purchased
or successfully reset (see Chapter 3.5 Removing
the devolo Magic adapter from a PLC network),
automatically start to attempt to pair (establish a
Powerline connection) with anotherdevolo Magic
adapter when reconnected to the mains supply.
Starting up a new devolo Magic PLC network
After plugging the devolo Magic adapters into
available power sockets, a new devolo Magic net-
work is established automatically within 3 minutes.
devolo Magic 1 WiFi mini
Expanding an existing devolo Magic Powerline
network by adding another devolo Magic
adapter
In order to use a new devolo Magic 1 WiFi mini in
your devolo Magic- network, first you have to
connect it to your existing devolo Magic adapters
devices as a network. This is accomplished by using
a shared Powerline password, which can be assi-
gned in various ways:
b
Using
devolo Cockpit
devolo Home Network App (see Chapter 3.4
Installation of devolo software)
b
Using the web interface (see Chapter 4.5
Powerline)
b
Using the Powerline button as described
below.
1
Plug the new devolo Magic adapter into an
available power socket and, for approximately
1 second,
press
the
devolo Magic
adapter
devolo Magic network.
2
The new devolo Magic adapter pairs automati-
cally so no button needs to be pressed. The LED
of this adapter now also flashes white.
For each pairing operation, only one additional
devolo Magic adapter can be added at a time.
or
the
PLC
button
on
a
in
your
existing
Advertisement
Table of Contents
