Spa Electrics LV50-12 Installation Manual

LV50-12
LOW VOLTAGE TRANSFORMER

INSTALLATION

Ensure that the unit is installed at least
3.5 metres away from the pool and/or
spa and at a minimum of 500mm above
ground level.
Fasten the transformer mounting
bracket to the wall. The transformer
can then be mounted onto the
bracket.

CABLE TERMINATION

The LV50-12 transformer has 2 outputs, each
with a pair of terminals. Each cable core should
be terminated as follows:
1. Loosen the terminal screw and clamp plate
from the terminal bolt. (These parts are joined
and will loosen together). You do not need to
fully remove the screw and clamp plate, only
loosen.
2. Place one of the stripped ends of the cable on
top of the terminal bolt. Tighten the clamp
plate and screw on top of the cable end to
secure it in place. As the Transformer outputs
AC power the cable orientation is not
important.
For the second cable core, repeat these steps
on the adjacent terminal.
Spa Electrics recommends the use of an Electrical
Contractor or Pool Technician for connection of the Pool
Light to the Transformer.
Do not remove the plug. This equipment MUST be
plugged into a protected outlet installed by an
Electrician.
FOR ASSISTANCE PLEASE
CONTACT SPA ELECTRICS
INSTALLATION GUIDE
ph: +61 3 9793 2299
info@spaelectrics.com.au
www.spaelectrics.com.au