SloanLED 60C3 Installation Manual

60C3 12 VDC Power Supply
Installation Guide for PN 701507-60C3 – NEC Class 2 Output
1. Tools required: Wire strippers,
drill, and screwdriver.
NOTE: Ensure adequate ventilation. Power supply operating ambient temperature is -40º to 60º C. Power supply must be mounted in an enclosure
(i.e., transformer can/raceway). Power supply spacing to thermoplastic, wood, fiber, or other combustible type enclosure materials shall be 1" (25
mm) Two or more adjacent power supplies shall not be mounted closer than 1" (25 mm) end to end or 4" (102 mm) side to side. If mounted inside
a sign cabinet, UL requires that cabinet is made from an enclosure rated material. Ensure power supplies are not overloaded by verifying output
current is less than 5 DC Amps. It is recommended to use photocells or light sensors to prolong life of power supply and to keep unit at maximum
operating efficiency.
2. Supplies required: Conduit and
electrical enclosure for power supply
(if not placed in a sign made from
enclosure rated material), #8 pan
head screws, UL Listed PLTC cable,
UL Listed electrical wire connectors
(e.g., wirenuts), silicone.
Europe: Electrical enclosure
for power supply, M4 pan head
screws, PLTC cable, silicone, 3M
Scotchlok connectors.
™
12 VDC Output
(Red & Black)
Mounting Tabs
Primary Wires (Brown & Blue)
3. Power Supply: Identify primary
wires, secondary wires, and
location of mounting tabs.
™
PAGE 1 OF 2
4. Mount Power Supplies:
Use mounting tab in corner to
secure power supply.
5. Connect Primary:
CAUTION: Have a licensed
electrician connect primary.
ATTENTION: Avoir un permis
électricien connecter primaire.