Speedlink PHOBOS SL-8265-BK - 2.1 Subwoofer System Quick Install Guide

Table of Contents

Contents

1 Quick Start
2 Intended use
3 Avoiding hearing damage
4 Declaration of Conformity
5 Technical support
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

Quick Start

Plug the subwoofer's power cable into an AC outlet (230V, 50Hz ~).
Connect the system to the PC: plug the accompanying audio cable's two phone/RCA connectors (red/white) into the Audio Input sockets on the subwoofer and the other end (green) into the audio output socket (usually green) on your soundcard.
Now plug the satellite speakers into the subwoofer: plug each satellite's phono connector into the relevant Audio Output socket on the subwoofer – red for right, white for the left channel.
Switch the system on (set POWER to ON).
Use the volume control on the desktop remote to adjust the volume level. Before playing back audio, make sure the volume level is set to minimum then slowly raise it.
Adjust the treble and bass levels to suit using the controls on the back of the subwoofer.

Intended use

This product is only intended as a speaker system for connecting to a computer or other audio source, and is designed for indoor use only. Jöllenbeck GmbH accepts no liability whatsoever for any damage to this product or injuries caused due to careless, improper or incorrect use of the product or use of the product for purposes not recommended by the manufacturer.

Place this device near an AC outlet that is easily accessible. This device will only be completely disconnected from the mains once it has been unplugged.

Avoiding hearing damage

PLEASE NOTE: Listening to audio for extended periods at loud volume levels may cause permanent hearing damage, so check the volume level that has been set on the volume control each time before using the product, and avoid listening to audio at a high volume level.

Declaration of Conformity

Operation of the device (the devices) may be affected by strong static, electrical or high-frequency fi elds (radio installations, mobile telephones, microwaves, electrostatic discharges). If this occurs, try increasing the distance from the devices causing the interference.

Technical support

Having technical problems with this product? Get in touch with our Support team – the quickest way is via our website: www.speedlink.com.

©2012 Jöllenbeck GmbH. All rights reserved. SPEEDLINK, the SPEEDLINK word mark and the SPEEDLINK swoosh are registered trademarks of Jöllenbeck GmbH. All trademarks are the property of their respective owner. Jöllenbeck GmbH shall not be made liable for any errors that may appear in this manual.
Information contained herein is subject to change without prior notice.
JÖLLENBECK GmbH, Kreuzberg 2, 27404 Weertzen, GERMANY

www.speedlink.com