Spin Master Bounce Round - Bouncy Castle Play Set Manual

Also See for Bounce Round:

Instruction manual (2 pages)

Table of Contents

Contents

1 Introduction
2 INSTRUCTIONS FOR SET UP
3 OPERATION TIPS
4 TO DEFLATE AND STORE THE SLIDE
5 STORAGE, CARE AND MAINTENANCE
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

Spin Master Bounce Round - Bouncy Castle Play Set Manual

Introduction

Please read the separate fan instructions before setting up the water slide.
(Fan instructions are included with fan).

ELECTRICALLY OPERATED PRODUCT
NOT RECOMMENDED FOR CHILDREN UNDER 3 YEARS OF AGE.
AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK.
ADULT SUPERVISION REQUIRED.

	Max Number of Children
	Max Individual Height
	Max Individual Weight
	Total Weight Limit
	Age 3+
	No Sharp Objects
	No Glasses
	No Jewelry
	No Shoes
	No Rough Play
	No Extension Cords

Failure to follow these instructions could result in serious injury or death.

Set up: By adults only.
During use: Adult supervision at all times.
Make sure grass is free from debris.
Use stakes to anchor to level ground and periodically check anchors are firmly staked.
Set up as close to power source as possible.

Assure the fan is in dry location while in use. Keep the fan away from water source.
Never slide head first, always slide feet first and make sure the slide is clear of people before sliding down.
Never stand on, pushing or jump from top slide platform.
Never leave children unattended. Keep infants away from pool! DROWING HAZARD! There is no substitute for constant adult supervision. Most drowning occurs during a five minute or less lapse in supervision, child can drown in as little as two inches (5 cm) of water.
Examine periodically for potentially unsafe conditions such as a damaged cord, plug, housing, parts or anchor loops. If damage is found, do NOT use until properly repaired.

Watch your step when entering or exiting the Water slide unit.
Keep all flame and heat sources away from this fabric. It is not fire proof. The fabric will burn if left in continuous contact with any flame source.
Children should not use Water Slide unit if they currently have, or have experienced, any of the following: neck or back injuries; respiratory conditions, such as asthma or bronchitis; chronic knee or other joint conditions; or any cardiac or circulatory problems.
Read and follow instructions in Instruction Manual.

warning
DO NOT:

Leave Water Slide unit or Fan outside in rain or elements when not in use.
Set up close to water, walls and other obstructions.
Jump on to or off of Water Slide unit.
Play with unevenly matched children. (Weight & height)
Grab onto the net. .

Set up when very windy.
Allow children near the fan.
Leave children unattended in the Water Slide unit at any time.
Setup close to traffic area.
Use an extension cord to plug in fan.

Do not place or drag on concrete or pavement or other rough surfaces. Must be used on a grass surface.
This unit has been purposely designed to allow air flow through its seams in order to achieve proper operation.
Do not attempt to seal as some air must be allowed to escape from the unit.

FOR PERSONAL HOME USE ONLY. Not intended for commercial and/or public use. (E.g. as a party rental product or for use in a gymnasium/ school). Water Slide products are not designed for commercial and/or public use.

DO NOT EXCEED WEIGHT LIMIT/MAXIMUM HEIGHT PER CHILD

Model #	Max # of Kids	Total Weight (Limit lbs/kg)	Maximum Individual Weight (lbs/kg)	Max Height/Child (ft/m)	C O N T E N T S
Model #	Max # of Kids	Total Weight (Limit lbs/kg)	Maximum Individual Weight (lbs/kg)	Max Height/Child (ft/m)	Slide	Slide Add-On	Hose Sprayer Assembly	Fan	Storage Bag	Fan Stakes	Slide Stakes	Water Bags	Ride- On
61460		100/45	100/45	5/1.5	1	1	1	1	1	4	TBD	2	0
61562		200/91	100/45	5/1.5	1	0	1	1	1	4	TBD	0	0
61578		100/45	100/45	5/1.5	1	0	1	1	1	4	TBD	2	0
61657		200/91	100/45	5/1.5	1	1	1	1	1	4	TBD	2	2

Keep Bounce "Round"^TM unit away from all heat and flame sources. The fabric on the Bounce "Round"^TM unit is NOT fire proof. The fabric will burn if left in continuous contact with any flame or heat source.

INSTRUCTIONS FOR SET UP

Adult Set Up and Supervision Required.

The Bounce 'Round^TM unit should be inflated or deflated only by an adult.

Make sure there are no pipelines or utilities under the ground beforeentering stakes. Unfold the un-inflated Water Slide unit on a grassy, level surface that is free of glass, rocks or other debris that can cause injury. Make sure the Water Slide unit is free from overhead power lines and obstructions.
Fill water bags* and attach to side of slide (B). (Water bags must be used so the slide will fully inflate. Never allow children to play on slide without installing water bags.) Anchor all hold-downs to the ground with the stakes provided. Angle stakes at a 45° angle away from unit (A). Periodically check while in use. Make sure Water Slide unit is at least 10 ft (3 m) away from other structures.

*Note: Not all slides require water bags.

Use on grass only. Do not drag or use on concrete.

Place fan unit away from water spray and ensure that water does not flow towards the fan. If watercontacts fan, disconnect power cord from wall plug. Do not resume operation until fan is completely dry.
Tie the long intake tube on the Water Slide unit around the mouth of the fan with the provided drawstring (C).
Tie the short release tube closed (if any), with the provided drawstring (D).
Make sure the intake tube has no kinks or folds and that the slide unit is securely anchored. Failure to take these precautions could result in injury during play.
Make sure that the fan switch is in the "OFF" position. Plug the fan into a properly grounded 110v outlet (See Grounding Instructions in Fan Instruction Sheet).
To inflate the slide unit, (press the resetbutton on GFCI) move the fan switch to the "ON" position. It should inflate in approximately 2 minutes.
Locate the spray hose attachment at top of slide.

Deflate the unit so you can attach the hose assembly. Attach the sprayer nozzles first (E) then attach the hose across the top of the unit and down the side of the slide with the (Hook & Loop) attachment tabs (F).
For model #'s 61657 and 61460 ONLY, add the slide extension to the end of the slide using the hook and loop fastener (G).
Turn the blower back on to fully inflate the unit.
Adjust position of fan to ensure there are no kinks or folds in the tube before staking fan down into its final position (H). Always make sure Water Slide fan is securely anchored to the ground with the stakes provided.
Attach the garden hose and turn spray unit on and begin play (I).

Do not allow children to play in the Water Slide unit until it is fully inflated. Never let children near the electric blower at any time.

After the Water Slide unit is fully inflated, leave the fan running during play.
AIR FLOW THROUGH SEAMS IS NORMAL. Do not try to seal seams.
To deflate the slide unit, move the fan switch to the "OFF" position.

Remove all children from the Water Slide unit before deflating.

OPERATION TIPS

Prohibit roughhousing by occupants.
Keep clean and dry between uses.
If there is any deflation occurring, ask the people in the Water Slide Unit to sit down and then unloadthem in a calm and orderly manner.
Keep all food, drinks, snacks and gum away from the Water Slide unit.
Keep all toys, party favors and silly string away from the Water Slide unit.
Consult the Weight/Height Chart to see maximum loads for individual rides. Do not exceed these requirements.
Make sure all stakes are planted firmly in the ground and check them regularly to make sure they are secure.
Do not inflate the unit in high winds (12.4 mph/20 kph), rain, or low temperatures (41°F/5°C).
To reduce the risk of fire or electrical shock, do not expose the blower to water or rain.
Do not use the fan in conditions of rainfall. Unplug the GFCI plug from power source.
Use the TEAR-AID^TM patch (included) to fix holes in your Water Slide unit by cutting patch to size, peeling off adhesive backing, and leaving for 24 hours to dry.

TO DEFLATE AND STORE THE SLIDE

Never store the Water Slide unit when wet. Always dry before rolling up and storing.

Remove all children from the Water Slide unit.
Turn water spray off and remove hose assembly. Carefully store hose assembly to avoid kinking.
Let fan run until unit is dry.
Remove all accessories from inside the Water Slide unit and be sure it is free of any debris or objects.
Turn off the fan (Refer to fan instructions for fan operation).
Disconnect the intake tube from the fan, and open the release tube*.
Allow the Water Slide unit to deflate completely. It should deflate on its own within 5 minutes.
Check the unit for wet spots and let the unit dry before storing the product.
Fold slide in half, by bringing pool end of unit up over the other end of slide. Fold it in half 2 more times or until unit is approximately as wide as the storage bag.
Roll it up tightly starting from the end opposite from the intake tube.
Slip storage bag over the rolled-up Water Slide unit.

Flip the bag and zip it closed.

*Not with all models.

STORAGE, CARE AND MAINTENANCE

The key to longevity is proper care and cleaning of the slide. A non-detergent cleaner such as Ivory^TM bar soap, not dish washing liquid! Can remove most stains. For stubborn stains or mold, Clorox^TM is recommended. Specifically, one (1) part Clorox^TM to nine (9) parts water.

Water Slide Unit is made of all new material.
Never store the Water Slide unit when wet. Allow to dry before rolling up.
Store the Water Slide unit and the fan in a dry place. Never leave either the Water Slide unit or the fanoutside in the rain or elements when not in use.
Do not immerse fan in water. Wipe clean with a damp cloth.
(Refer to fan instructions for fan maintenance).

Spin Master Ltd., 450 Front St. W. Toronto ON M5V 1B6 Canada
1-800-622-8339
www.spinmaster.com
MADE IN CHINA.