Develco Squid.link - Gateway Manual

Product description

The Squid.link Gateway is an open Linux platform including multiple wireless networks for communication with smart meters, sensors, smart plugs, thermostats etc.
The gateway is modular and can handle many different wireless protocols at the same time.

Getting started

1. Connect the power cable to the Squid.link Gateway.
2. Connect the power adapter to a wall socket.
3. Connect an Ethernet cable from the Squid. link Gateway to an internet-connected
   
4. The LEDs on the front panel are turned on when the system is booting.
5. The LEDs in the Ethernet connector are turned on and the green LED starts flashing indicating data communication.
6. After approximately 4-5 minutes the application is started and the system is ready for use.

Resetting

A factory reset is needed to remove abnormal behavior.

STEPS FOR RESETTING

1. Use a pen and hold down the reset button as indicated in the picture.
2. Release the pen again when the LED on the front panel starts to flash continuously.
   
3. The system will reboot and after 4-5 minutes the application will be started again.

Disposal

• Dispose the product properly at the end of life. This is electronic waste which should be recycled.

Precautions

• Do not remove the product label as it contains important information.