Soundcore Life Q10 - Wireless Bluetooth Headphones Manual

Charging Your Headphones

	Flashing red once every 30 seconds	Low battery
	Steady red	Charging (Note: Do not power on Life Q10 while charging)
	Steady blue	Fully charged

Powering On / Off

Power on		Press and hold for 3 seconds		Steady blue for 1 second
Power off		Press and hold for 3 seconds		Steady red for 1 second

Pairing

Enter Bluetooth pairing mode when Life Q10 is off				Press and hold for 5 seconds
Enter Multipoint pairing mode				Press and hold for 3 seconds simultaneously
	Rapidly flashing blue	Pairing mode
	Steady blue	Connected to a device

• Once entered in multipoint pairing mode, you can manually connect a second mobile device to your Soundcore Life Q10.
• Soundcore Life Q10 can only play music on one mobile device at a time.
• Each time you power on your Soundcore Life Q10, it will automatically connect to your last successfully connected device if available.

Controls

Play / pause		Press
Next track		Press and hold for 1 second
Previous track		Press and hold for 1 second
Volume up / down		Press
BassUP™ Mode (Dual Equalizer)		Press
Answer / End a call		Press
Put the current call on hold and answer a new incoming call
Reject a call Switch between held call and active call		Press and hold for 1 second
Activate Siri or other voice assistant software		Press and hold for 1 second

AUX-in

Plugging in an audio cable will automatically switch to AUX mode, and Bluetooth mode will turn off.

Specifications

Specifications are subject to change without notice.

Input	5 V0.65 A
Charging time	2 hours
Playtime	60 hours
Impedance	16 Ω
Driver size	40 mm × 2
Frequency response	16 Hz - 40 kHz
Bluetooth version	V5.0
Bluetooth range	15 m / 49.5 ft

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Soundcore Life Q10 - Wireless Bluetooth Headphones Manual