Starting-Up The Purifier; Recommended Usage Of Rejected Water; Maintenance; Important Safety Instructions - Oasis 50 LPH RO Instruction Handbook For Installation, Operation And Maintenance

Reverse osmosis system

Table of Contents

Starting-up the Puriﬁer

• Switch on the power supply

• Allow water to ﬁll to the maximum level

• Switch oﬀ the power supply

• Open the faucet and drain water to remove residual dust particles present in

the pipes and tank

• Close the faucet and switch on the

power supply

• Puriﬁer is ready to use

Although the rejected water has high concentration of salts, it is absolutely clean and free from

impurities like chlorine, dirt, sand, etc. This rejected water usually goes down the drain but can be

used for gardening purpose. The high concentration of salts and minerals accelerate the plant

growth. Rejected water can also be used for cleaning utensils, mopping etc.

To ensure that the puriﬁer operates at its BEST, a routine maintenance must be performed. The

frequency of the maintenance will greatly depend upon the raw water quality and consumption

of puriﬁed water.

• Tank must be drained and cleaned once in every 15 days

• Replace RO membranes once in a year

• Replace sediment ﬁlter, activated carbon ﬁlter once in a year or earlier if they get clogged.

It is recommended to change FRT along with the ﬁlters

Please note that the replacement time of consumables such as ﬁlters and membranes is

dependent on the quality of raw water and the quantity of water consumed.

• If the supply cord is damaged, it must be replaced by the original part in order to avoid hazard

• Children should be supervised to ensure that they do not play with the appliance

• This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety

• Read the maintenance instructions before opening the appliance

• The appliance must be disconnected from the supply before replacing the ﬁlters.

Table of Contents