Page 3
45 - 65 Hz, and the form of the voltage at the output should be Pure sine wave. If these conditions are not met, the stabilizer and generator may not work correctly. Technical support: www.real-el.com...
This dependence is schematically shown in the graph below: Note. In the process of selection and further operation, it is necessary to clearly observe this dependence. In case of non-compliance with the specified condition, the right to warranty repair is lost! Technical support: www.real-el.com...
After the input voltage returns to the range of 150-270 V, the AVR automatically resumes operation. • In case of overload or short circuit, the circuit breaker will trip. After eliminating the cause of overload or short circuit, press the switch button (RESET position) and the AVR will resume operation. Technical support: www.real-el.com...
Cause Explanation Problem Cause Solution 12. TECHNICAL SPECIFICATIONS Model STAB WM-5000 STAB WM-10000 Maximum load 5000 VА \ 4000 W 10000 VА \ 8000 W Input voltage ~150 – 270 V \ 50 Hz ~150 – 270 V \ 50 Hz Output voltage ~230 V ±...
Page 8
Models: STAB WM-500, STAB WM-10000 Manufacturer: ENEL GROUP OU, Katusepapi tn 6, Lasnamäe linnaosa, Tallinn, Harju maakond, 11412, Estonia. Made in China. ® Registered Trademark of ENEL GROUP OU. Estonia.