Real-El STAB WM-5000 Operation Manual

Real-El STAB WM-5000 Operation Manual

Automatic voltage regulator

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Real-El STAB WM-5000

  • Page 2: Table Of Contents

    Congratulations on your purchase of the REAL-EL products! Please read this Operation Manual before using the unit and retain this Operation Manual in a safe place for future reference. COPYRIGHT © 2023. ENEL GROUP OU. This manual and information contained in it are copyrighted. All rights reserved.
  • Page 3 45 - 65 Hz, and the form of the voltage at the output should be Pure sine wave. If these conditions are not met, the stabilizer and generator may not work correctly. Technical support: www.real-el.com...
  • Page 4: Technical Description

    LOADNG CAPACITY STAB WM-5000 STAB WM-10000 5. TECHNICAL DESCRIPTION Output voltage indicator Delay activation indicator Overload indicator Under voltage protection Over voltage protection Indicator of input voltage Loading capacity AVR switch with built-in fuse Delay switch 6/180 sec Input/output connection terminal Wall mounting holes Technical support: www.real-el.com...
  • Page 5: Installation

    This dependence is schematically shown in the graph below: Note. In the process of selection and further operation, it is necessary to clearly observe this dependence. In case of non-compliance with the specified condition, the right to warranty repair is lost! Technical support: www.real-el.com...
  • Page 6: Pause" Function

    After the input voltage returns to the range of 150-270 V, the AVR automatically resumes operation. • In case of overload or short circuit, the circuit breaker will trip. After eliminating the cause of overload or short circuit, press the switch button (RESET position) and the AVR will resume operation. Technical support: www.real-el.com...
  • Page 7: Not A Fault

    Cause Explanation Problem Cause Solution 12. TECHNICAL SPECIFICATIONS Model STAB WM-5000 STAB WM-10000 Maximum load 5000 VА \ 4000 W 10000 VА \ 8000 W Input voltage ~150 – 270 V \ 50 Hz ~150 – 270 V \ 50 Hz Output voltage ~230 V ±...
  • Page 8 Models: STAB WM-500, STAB WM-10000 Manufacturer: ENEL GROUP OU, Katusepapi tn 6, Lasnamäe linnaosa, Tallinn, Harju maakond, 11412, Estonia. Made in China. ® Registered Trademark of ENEL GROUP OU. Estonia.

This manual is also suitable for:

Stab wm-10000

Table of Contents