Advertisement
Non-Penetrating Antenna Peak Roof Mount 34-inch Pole Only
HGX-PRM-ARM
Note:
•
Ballast data should be determined by a local professional engineer. Adequate ballast material
must be determined and provided by others
Prior to installation, verify that the installation, roof material and supporting structures have
•
been investigated and found capable to withstand load
•
Place ballast material (i.e., cinder blocks, concrete blocks, etc.) evenly on both side with at least
4 on each side, total 8 blocks per mount approx. 300lbs over all base angles (Estimated
Operational Ballast)
•
All antenna installations MUST be grounded
L-Com RECOMMENDS THAT BALLAST MATERIAL ALWAYS BE PLACED PRIOR TO MOUNTING
•
ANTENNAS AND THAT THE MOUNT BE SECURED TO PREVENT HAZARDS FROM OCCURRING
UNDER EXTREME WIND LOADING CONDITION
Inspect all bolts and screws for optimal tightness (recommended torque 13-14 lbs-ft.) to ensure
•
there is no loose gaps after installation
•
Recommended to use self -tapping screws provided with mount to reduce the loading of the
roof if working environment is allowed to drill
Inspect the mount, antennas, and tightness of nuts at six-month maximum intervals
•
Operational
Survival
CONTACT A LOCAL PROFESSIONAL ENGINEER TO DETERMINE PROPER LOADING vs BALLAST WEIGHTS
Operational: It is workable under 50km/h wind speeds.
Survival: The products may be deformed but will not fly away.
Mechanical Specifications
Size
2
50 Km/h (31 mph)
100 Km/h (62 mph)
HGX-PRM-ARM REV 1.1 | © 2020 Infinite Electronics, Inc. L-com is a registered trademark of Infinite Electronics, Inc.
USA & Canada +1(800) 341-5266 | International +1(978) 682-6936 |
Under recommended Load
Under recommended Load
L-com.com
Advertisement
