Table of Contents
Advertisement
Available languages
Available languages
The source device should also be at least HDMI 2.0a
compatible in this case. In the Picture Mode menu
three predefined picture modes will be available
if Dolby Vision content is detected: Dolby Vision
Bright, Dolby Vision Dark and Dolby Vision Vivid.
All allow the user to experience the content in the way
the creator originally intended with different ambient
lighting conditions. To change the Picture Mode setting
press the Menu button while watching the Dolby Vision
content and go to Picture menu. While watching Dolby
Vision Content via an application, except YouTube,
Netflix and Multi Media Player, you will not be able to
access the Picture menu and set the Picture Mode.
Antenna Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket located on the left side of the TV
or satellite plug to the SATELLITE INPUT (LNB) socket
located on the rear side of the TV.
Left side of the TV
ANT
Rear side of the TV
LNB
If you want to connect a device to the TV, make
sure that both the TV and the device are turned off
before making any connection. After the connection
is done, you can turn on the units and use them.
Stand Installation &
Wall Mounting
Assembling / Removing the pedestal
Preparations
Take out the pedestal(s) and the TV from the packing
case and put the TV onto a work table with the screen
panel down on a clean and soft cloth (blanket, etc.).
• Use a flat and firm table bigger than the TV.
• Do not hold the screen panel part.
• Make sure not to scratch or break the TV.
Assembling the pedestal
1.
Place the pedestal(s) on the mounting pattern(s)
on the rear side of the TV.
2.
Insert the screws provided and tighten them gently
until the pedestal(s) is/are properly fitted.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall mount bracket or repacking the TV.
• Put the TV onto a work table with the screen panel
down on a clean and soft cloth. Leave the pedestal(s)
protruding over the edge of the surface.
• Unscrew the screws that fix the pedestal(s).
• Remove the pedestal(s).
When using the wall mount bracket
Your TV is also prepared for a VESA-compliant wall
mount bracket. If it is not supplied with your TV, contact
your local dealer to purchase the recommended wall
mount bracket.
Holes and measurements for the wall mount bracket
installation;
VESA WALL MOUNT MEASUREMENTS
Hole Pattern
Sizes (mm)
Length (X)
Thread (Y)
English - 5 -
W
H
W
H
100
100
Screw Sizes
min. (mm)
max. (mm)
M4
7
8
Advertisement
Chapters
Table of Contents
