Advertisement
OEM Installation Guidance Document
For BRCM WLAN Module, BCM94319SDB
FCC ID: QDS-BRCM1056; IC: 4324A-BRCM1056
are strictly prohibited for use with this device. The required antenna impedance is
50ohms.
Caution: (this only applicable to UNII device)
This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz
frequency range. Industry Canada requires this product to be used indoors for frequency
range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel
Mobile Satellite systems.
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to
5.85 GHz bands. These radar stations can cause interference with and/or damage this
device.
Caution: Exposure to Radio Frequency Radiation.
To comply with RSS 102 RF exposure compliance requirements, for mobile
configurations, a separation distance of at least 20 cm must be maintained between the
antenna of this device and all persons. This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
System integrators must include the IC ID on the end product.
3. Europe - EU Restrictions
0984
This equipment needs to be marked with the
symbol and can be used
throughout the European community.
Marking by the symbol
indicates that usage restrictions apply.
Information to be supplied to the users:
802.11a Restrictions:
- This product is for indoor use only when using channels 36, 40, 44, 48, 52, 56, 60, or 64 (5150–
5350 MHz).
- DFS and TPC must remain enabled to ensure product compliance with EC regulations.
- To ensure compliance with local regulations, be sure to select the country in which the access
point is installed.
- This product can be used as shown in the table below:
Page 4 of 8
Advertisement
