Advertisement
Signal connections
Input and output connections to the amp are
made using F-type (IEC 60169-24) connectors.
Connections can be made using a tool for
crimp or compression connectors or by hand
with twist-on connectors (see Fig.1 opposite).
Ensure that the correct size connector is used
to match the size of the coax cable.
Make sure that the external connections are
adequately weatherproofed to prevent water
ingress which could damage your amplifier.
2 –Year Guarantee
Your amplifier is guaranteed against faulty components or poor
workmanship for a period of two years from the date of purchase.
This guarantee does not cover accidental or malicious damage
(Including damage from natural causes such as lightning) and will be
invalidated by installation or use other than in accordance with these
instructions, repair or attempted repair other than by the manufacturer, or
opening or removal of the case. This does not affect your statutory rights.
Labgear Reserve the right to modify their designs or specifications, In the light of future
developments, without prior notice. Performance figures quoted are typical and subject to
normal manufacturing and service tolerances.
This product is intended for use within the UK and Eire.
Declaration of Conformity
Hereby, Labgear declares that this amplifier for TV broadcast reception in domestic premises is in
compliance with the Radio Equipment Directive 2014/53/EU.
The full Declaration of Conformity is available by contacting the following internet address: www.
labgear.co.uk/DoC
Technical Support
For further help, advice or information visit
Our website www.labgear.co.uk
Technical team www.labgear.co.uk/technical
Email: technical@labgear.co.uk
or live chat during office hours via our website
Bedford MK42 0NX
www.labgear.co.uk
4
Guarantee and Technical Support
Fig. 1
cut or tear
away foil
fold braid back
over sheath
screw connector
body onto cable
Member
No. M. 1125
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority for
recycling advice.
COMPLIANT
8mm
6mm
inner wire
end of insulation
should be flush
with this face
2mm approx.
© Philex Electronic Ltd. 2017 V1
Advertisement
