Table of Contents
Advertisement
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
1. Using a spanner, unscrew and remove the
rear right-hand bolt and lay the machine on
its back, taking care not to squash the hoses.
This can be avoided by placing one of the
corner packing pieces between the machine
and the floor.
2. Remove the polystyrene blocks from the
underside of the machine and release the two
plastic bags by removing the adhesive strip.
3. Carefully remove the right-hand bag (1) then
the left-hand bag (2) by pulling them towards
the centre of the machine.
4. Unscrew and remove the feet.
5. Fit the grid (A) on the bottom of the machine
and re-fit the feet after having inserted the
washers (B) you will find in the bag
containing the instruction booklet.
6. Set the machine upright and remove the two
remaining bolts from the back.
7. Pull out the three plastic spacers from the
holes into which the bolts were fitted.
8. Plug the open holes with the plugs which you
will find at the back of the machine.
6
INSTALLATION
P0255
P0802
A
P1048
P0256
2
1
P0233
B
P0020
Advertisement
Table of Contents
